The history of time contains many amusing quirks. In many cases, Noda Time doesn't make any attempt to support the oddities described below. In particular, Noda Time takes an idealized view of calendar systems, ignoring (for example) the fact that countries have switched between calendar systems (and sometimes invented calendar systems) at various points in recent history. Still, it's fun to think about what's happened over time, if only to persuade you that it would be much worse if Noda Time did try to support them...
More will be added as I discover them.
In 2011, Samoa (time zone ID
Pacific/Apia) decided to change their UTC
offset from UTC-10 to UTC+14. This means they went from being the
western-most time zone (the further behind UTC) to the eastern-most time
zone (the furthest ahead of UTC). This took place at midnight local time at
the end of December 29th, so the local time for the few seconds around this
As an act, it made a certain amount of sense: Samoa does a lot of trade with Australia and New Zealand, and I can imagine it was a pain being a day behind them most of the time. Additionally, this means that hotels in Samoa can offer the experience of being "the first to experience the New Year" for tourists who are particularly keen on that sort of thing.
However, I question the wisdom of making the transition occur at midnight, which made December 30th not occur at all. I suspect that a transition at (say) 3am would have been cleaner, leading to a day lasting only three hours followed by a day lasting twenty one hours. While this is mostly a problem for computers, I would expect many automated systems to get thoroughly confused by a day not happening at all. (The counter-argument is that it's possible that a few automated systems would cope with two significantly shorter days, too...)
Pacific/Apia isn't the only time zone to have made this sort of
transition, although it is the largest population to do so, as far as I'm
Noda Time support: fully supported!
DateTimeZoneProviders.Tzdb["Pacific/Apia"].AtStartOfDay(new LocalDate(2011, 12, 30)) will throw a
SkippedTimeException to indicate that the day never
Many people understand the leap year rule for the Gregorian calendar: a year number denotes a leap year if it's divisible by 4, except when it's also divisible by 100, except that what it's also divisible by 400 it is a leap year again. This system was devised to keep the length of a calendar year very close to the solar year. It's more accurate than the Julian calendar system, which simply has every 4th year being a leap year. This is a little bit like 3 being a very bad approximation for π, while 22/7 is more accurate but also more complicated. In this case, it means that there are more leap years in the Julian calendar system than in the Gregorian calendar system: if you run the two side-by-side from the same start date, the Gregorian system will gradually get further ahead of the Julian system by including fewer February 29th days.
Many countries switched from the Julian calendar system to the Gregorian calendar system in the 16th and 18th centuries. Most made this change by skipping ten or eleven days to "catch up" with where the Gregorian calendar would be if the two calendars had both started with the same date at some point in the 3rd century AD. For example, when Great Britain made the change in September 1752, September 2nd was followed by September 14th.
Sweden did things a little differently. Rather than skipping lots of days all in one go, they decided to skip February 29th altogether from 1700, until they'd missed enough leap years to catch up to the Gregorian calendar. So instead of being first correct in one calendar system and then the next day correct in a different system (albeit leading to a very short month and year), they'd be somewhere in between for about 40 years.
While this almost sounds like a reasonable plan (almost like the way that Google "smears" a leap second across a whole minute rather than simply adding a second), it went horribly wrong. In February 1700, Sweden skipped the leap year, according to plan. That meant that they were one day ahead of the countries still following the Julian calendar. Unfortunately, in the same year - although ironically before February 28th - the Great Northern War broke out. This distracted Sweden from their calendrical machinations, and they did have a leap year in 1704 and 1708.
At this point the Swedes apparently realized they were in a crazy situation, and decided to go back to the Julian calendar. In order to do that, they had to to insert the leap year they'd missed in 1700 back into their calendar. They could have done so in a regular year (1710 for example), just making that an extra leap year - but no, they decided to make 1712 a double leap year, by giving February 30 days. Sweden made the final change to the Gregorian calendar in the "normal" way of skipping 11 days, in February 1753.
So there we have it: February 30th was only a valid date once, and in one place: 1712 in Sweden.
Noda Time support: Absolutely not. Noda Time doesn't support calendars cutting over from the Julian to the Gregorian calendar system anyway, let alone in such an odd way.
Many developers know that the Unix epoch is midnight on January 1st 1970 UTC1. Those who are aware that UTC itself was only introduced in 1972, and so to avoid applying it proleptically, decide to instead say that it was midnight on January 1st 1970 at Greenwich, expecting that Greenwich would be using GMT (Greenwich Mean Time) at the epoch.
Unfortunately, that's incorrect. At the Unix epoch, the time in London was observing British Standard Time, which had been introduced in 1968. During British Standard Time, the United Kingdom did not observe daylight saving, but instead used UTC+1 for the entire period, until it was scrapped in 1971.
There are thus two British time zones abbreviated to "BST" - "British Standard Time" and the rather more common "British Summer Time". Both have an overall offset from UTC of 1 hour, but British Standard Time has a "standard" offset of 1 hour from UTC with no daylight saving component, and British Summer Time has a standard offset of 0 hours from UTC, but one hour of daylight saving time.
The Java standard library has a known
bug on this matter. When
formatting the Unix epoch in the
Europe/London time zone, it correctly
gives output of 1am, but incorrectly states that the time zone abbreviation
Noda Time support: Correct, but only by virtue of writing this article. Until late January 2014, the time zone data compiler considered a time zone transition to be invalid unless it either changed the name or the wall offset. The transition from summer time to standard time on October 27th 1968 was therefore ignored.
1 I'm studiously avoiding the differentiation between, UTC, UT, UT0, TAI and the like. They make my head hurt, and in common usage time zone offsets are given relative to UTC.
How would you define midnight? There are two obvious ways to do this:
You might expect these to be the same, but in reality they're not. In most time zones, transitions (usually for daylight saving changes) occur in the early morning - often 1am or 2am. However, a surprising number of time zones have had at least one transition which started at midnight - typically skipping forward, so that midnight didn't actually occur. I first came up against the problem when modelling all-day calendar events as events that started and ended at midnight. That's not so smart in São Paulo (as one example) when midnight doesn't always exist - at least if we assume that "midnight" is "12am".
The smart approach is to effectively use the second definition: when one day becomes the next.
Noda Time support: Although
LocalTime supports the idea of midnight,
if you want to convert a
LocalDate into a
ZonedDateTime, you'd typically use
which avoids the problem - so long as the date hasn't been skipped as we saw
I mentioned earlier that Great Britain changed from the Julian calendar to the Gregorian calendar in 1752... but the same Act of Parliament which made that change also changed the year numbering system in most of Great Britain. Before then, March 25th (Lady Day, celebrating the Annunciation) was deemed to be the start of the year. So for example, in the early 1700s the dates would run:
Due to the Calendar (New Style) act, 1751 was the last year for which this was true. December 31st 1751 was followed by January 1st 1752, leaving 1751 as a very short year (only 282 days). 1752 was also a short year (355 days) due to the transition to the Gregorian calendar system skipping 11 days of September.
For some reason, the Treasury decided it was too awkward to have tax years that were short like this. Therefore in 1752 the tax year still started on March 25th, and in 1753 it started on April 5th. In 1800, for reasons we1 haven't yet discovered, the Treasury decided it still liked the Julian calendar's way of determining leap years, so around2 1800 the tax year shifted by another day, to April 6th - where it was remained ever since.
All of this means that when you see a date in history, you need to be very careful before you compare it with another date. To avoid too much confusion, many historical dates are given using the Julian calendar, which was being observed at the time (depending on the place, of course), while using the "New Style" of year numbering. For example, Henry VIII died on January 28th 1547 (New Style) or January 28th 1546 (Old Style). In my experience, some web pages explicitly call out which numbering style they're using, others record it as "January 28th 1546/1547" and hope that readers understand why, and others just use the New Style without any explanation.
It's unclear to me at the moment whether before 1752, January 1st was still celebrated as "the New Year". It wouldn't be the New Year according to the obvious definition ("when the year number changes") but given that humanity never seems to miss a chance for a party, I suspect there were festivities anyway.
Noda Time support: Definitely not, although it would be possible...
1 When I say "we" here, I really mean "Malcolm" who did most of the work on understanding this issue based on Wikipedia and primary sources... 2 Possibly 1800, possibly 1801 - we haven't found details yet, and it would depend on whether the Treasury was considering the tax year for 1800, or the calendar year for 1800 to be a leap year.
You might expect that time zone changes are planned years in advance, to avoid confusion when planning events. Alas, it is not so. My first encounter with a short amount of warning for a time zone change was in 2009. I was working on Google Mobile Sync at the time, synchronizing calendars. One day, a unit test failed. It was trying to infer a correct time zone from a very broken representation, and it mistook the time zone in Greenland for the one in Argentina. This was partly due to a bug in my own code, but the sudden nature of the problem was due to Argentina giving a mere 11 days of notice of their decision to cancel daylight saving time for 2009/2010. This was due to a large amount of rainfall in 2009, leading to full hydroelectric dams. The Argentine government considered that one of the major benefits of daylight saving time was reduced electricity consumption, and so when the dams were full, there was less reason to observe the change. This was the first - and I hope the last - time that a unit test failure was caused by the weather.
Since then, I've learned that this isn't as rare an occurrence as one would hope - and that 11 days is quite a lot of notice compared with some examples. In 2013, both Morocco and Libya gave less than a day's notice that they were changing their time zone rules, leaving a certain amount of confusion in their wake.
In 2011, Turkey gave a fair amount of warning (over two weeks!) that it was delaying the DST transition, just by a single day, but the reason was slightly odd - a nationwide exam that 1.5 million students were taking.
Noda Time support: Well, there are five steps which need to occur between a change being announced and Noda Time supporting it in production:
As you can see, this depends on a lot of different people, so some delay is inevitable. However, if your application is configured to poll the web site reasonably often (once a day, for example) you're likely to see changes applied within a week of them being announced (and of course, you can always build the NZD file yourself). That's considerably quicker than Microsoft typically deploys changes to the Windows time zone database...